Names And Functions Of Indications On Remote Controller - Toshiba RAS-M10GDCV-E Owner's Manual

NAMES AND FUNCTIONS OF INDICATIONS ON REMOTE
CONTROLLER
Display
All indications, except for clock time indication, are indicated by
pushing the START/STOP button.
a Transmission mark
This transmission mark
controller transmits signals to the indoor unit.
b Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Cool, : Dry, : Heat,
c Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
temperature setting is indicated.
d FAN speed display
Indicates the selected fan speed. AUTO or one of five fan
speed levels (LOW , LOW
, HIGH ) can be indicated.
Indicates AUTO when the operating mode is either AUTO
or : Dry.
e TIMER and clock time display
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER
operation.
f High power display
Indicates when the High power operation starts.
Push the Hi-POWER button to start and push it again to
stop the operation.
g (MEMORY) display
Flashes for 3 seconds when the MEMO button is pushed
during operation.
mark is indicated when the button is not pushed for
more than 3 seconds while the mark is flashing.
Push another button to turn off the mark.
h ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display changes
in the sequence of 1, 3, 5, or 9h.
i A, B change indication remote controller
Push the "CHECK" point and "MODE" button at once, for
changing remote controller setting from "A" to "B". (Priority
is given to "A" setting.)
The switch panel of indoor unit is also changed to "B"
setting.
indicates when the remote
: Fan only)
: Fan only, no
+ +
, MED , MED
• In the illustration, all indications are indicated for
explanation.
During operation, only the relevant indications will
be indicated on the remote controller.
7 EN