Toshiba RAV-SM562KRT-E Owner's Manual page 21

Operation section
Push each button to select a desired operation.
This remote controller can operate the maximum 8 indoor units.
• The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing
ON / OFF
button only.
!
2
5
3
1 Air volume select button 1 1 1 1
Selects the desired air volume mode.
The Concealed Duct High Static Pressure type
models cannot be operated.
2 Timer set button 2 2
2 2
TIMER SET button is used when the timer is set
up.
3 3
3 3 Check button 3
The CHECK button is used for the check opera-
tion. During normal operation, do not use this
button.
4 4
4 Fan button 4 4
FAN button is used when a fan which is sold on
the market or etc. is connected.
• If
is displayed on the remote controller when
pushing the FAN button, a fan is not connected.
5 Filter reset button 5 5 5 5
Resets (Erases) "FILTER
6 6 Wind direction and Swing 6
6 6
UNIT
: If the multiple indoor units are operated
by only one remote controller, select the
units when the air direction is adjusted.
SWING/FIX
: Set up the auto swing and angle of the
flap.
1
TEMP.
TIMER SET
TIME
FILTER
RESET TEST SET CL
" display.
16
7
ON / OFF
FAN MODE
SWING/FIX VENT
UNIT
7 7 Operation lamp 7 7 7
Lamp is lit during the operation. Lamp is off when
stopped.
Although it flashes when operating the protection
device or abnormal time.
ON / OFF
8 8 8 8 8
button
When the button is pushed, the operation starts, and it
stops by pushing the button again.
When the operation has stopped, the operation lamp
and all the displays disappear.
9 9 Operation select button 9
9 9
Selects desired operation mode.
! !
! Set up temperature button ! !
Adjusts the room temperature.
Set the desired set temperature by pushing
or .
Remote controller sensor
Usually the TEMP. sensor of the indoor unit senses the
temperature. The temperature on the surrounding of the
remote controller can also be sensed.
For details, contact the dealer from which you have
purchased the air conditioner.
• In case that one remote controller controls the multiple
indoor units, the setup operation is unavailable in group
control.
8
9
4
6
EN