Positioning The Logs - Quadra-Fire TOPAZ 839-1290 Installation And Operation Maintenance Owner's Manual

Install left or right side panel. Place in lower chan-
Figure 8.16
nel and rotate into place.
NOTE: Side brick panels will fit only if installed at an angle.
Do not attempt to push the brick flat against the outer wall
of the firebox. Brick should rest against spacer on inside of
firebox.
Bend over tabs to hold panel in place.
Figure 8.17
Install the top panel/baffle. If rear venting, set damper prior
to installing the top panel/baffle. (In the Commonwealth of
Massachusetts, the word damper shall be replaced with the
word damper shall be replaced with the words fl ue restrictor.)
The back edge will slide in front of the rear brick panel. Rest
one end of the top panel/baffl e on the installed side panel
and support the other end with one hand.
Install the remaining side panel and bend over the tabs to
hold it in place. Rest top panel/baffl e on sides and slide top
panel/baffl e left or right until centered.
32
Figure 8.18
installed the firebox is narrower at the back than in the front.
G. Positioning the Logs
While still breakable, the logs do not become fragile until
after the appliance is burned and they have cured. After
curing, any handling must be done with care as breakage
can easily occur.
PLEASE NOTE:
specifically with the burner of this appliance. Exact
placement will ensure proper operation of your gas
appliance and reduce sooting.
Figure 8.19
consists of the following:
Quadra-Fire • Topaz • 7009-113 Rev. Q • 6/14
Fully installed brick set. Note that with the brick
Logs have been designed to work
1
The log set is packed in the components box and
Qty. Description
1 Rear Log
1 Left Front Log
1 Right Front Log
1 Right Twig
1 Left Twig
#
1
2
3
4
5