Section 2: Getting Started; Design & Installation Considerations; Tools And Supplies Needed; Inspect Appliance & Components - Quadra-Fire TOPAZ 839-1290 Installation And Operation Maintenance Owner's Manual

2
Getting Started
A. Design & Installation Considerations
Quadra-Fire direct vent gas appliances are designed to
operate with all combustion air drawn from outside of the
building and all exhaust gases expelled to the outside. No
additional air source is required.
CAUTION
Check building codes prior to installation.
• Installation MUST comply with local, regional, state
and national codes and regulations.
• Consult local building, fi re offi cials or authorities having
jurisdiction about restrictions, installation inspection,
and permits.
When planning an installation, it is necessary to determine
the following information before installing:
• Where the appliance is to be installed.
• The vent system confi guration to be used.
• Gas supply piping.
•
Electrical wiring.
• Whether optional accessories - devices such as a blower,
thermostat or remote control - are desired.
WARNING
Keep appliance dry.
• Mold or rust may cause odors.
• Water may damage controls.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available. Note: Not all
tools will apply to every installation.
Reciprocating saw
Pliers
Hammer
Phillips Screwdriver
Flat Blade Screwdriver
Plumb Line
Level
Manometer
Non-corrosive Leak Check Solution or combustible gas
detector
Caulking material (300ºF minimum continuous exposure
rating)
6
Variable Speed Drill/Driver
Wrench Set
Framing Square
Framing Material
Voltmeter
Gloves
Safety Glasses
Tape Measure
Quadra-Fire • Topaz • 7009-113 Rev. Q • 6/14
C. Inspect Appliance & Components
WARNING
Inspect appliance and components for
damage. Damaged parts may impair safe
operation.
• Do NOT install damaged components.
• Do NOT install incomplete components.
• Do NOT install substitute components.
Report damaged parts to dealer.
• Carefully remove the appliance and components from
the packaging.
• Remove cast door and glass door, and set aside on pro-
tective surface. See page 34.
• Remove log set and component pack from fi rebox.
• Report to your dealer any parts damaged in shipment,
particularly the condition of the glass.
• Read all of the instructions before starting the instal-
lation. Follow these instructions carefully during the
installation to ensure maximum safety and benefi t.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance or vent
system component.
• Modifi cation of the appliance or vent system.
• Installation other than as instructed by Hearth & Home
Technologies.
• Improper positioning of the gas logs or the glass door.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fi re hazard.