Get The Model Ready To Fly; Check The Control Directions - Hobbico Superstar EP Select Assembly Instructions Manual

3. Tape the receiver antenna to the upper side of
the fin. Do not shorten the receiver antenna.
Shortening the receiver antenna will reduce the
receiver's range.

Get the Model Ready to Fly

Check the Control Directions

1. Switch on the transmitter, connect the charged
motor battery to the electronic speed control and
switch on the speed control. Center the trims. If
necessary, remove the servo arms from the servos
and reposition them so they are centered. Reinstall
the screws that hold on the servo arms.
2. With the transmitter and receiver still on,
check all the control surfaces to see if they are
centered. The top of the elevator should be flat with
the top of the stabilizer and the rudder should be
inline with the fin. If necessary, loosen the 4-40
socket head cap screws in the screw-lock pushrod
connectors and adjust the pushrods to center the
control surfaces.
Motor Off
3. Make certain that the control surfaces respond
in the correct direction as shown in the diagram. If
any of the controls respond in the wrong direction,
use the servo reversing switch in the transmitter to
reverse the servos connected to those controls. Be
certain the control surfaces have remained
centered. Adjust if necessary. With the prop still not
installed, check that the throttle lever is in the off
position or low throttle. To start the motor, the start
button must be pressed after the electronic speed
control is switched on.
9
Elevator Moves Down
Rudder Moves Right
Motor Runs