IKEA GRILJERA User Manual page 26

ENGLISH
Gas connection
WARNING! This operation must be
performed by a qualified technician.
For information regarding gas connection
instructions, see the injectors table and the
"standard" relevant to your country.
The gas supply system must comply with current
local regulations.
The appliance must be connected to the
gas supply or gas bottle by means of a rigid
copper, steel pipe or rubber hose based on
local regulation.
The maximum length of the hose is 2 m.
The hose must be connected directly to the
outlet connector (Fig. 1), after first of all ensuring
you remove any extension cable fitted to your
appliance.
IMPORTANT: when using a rubber hose,
i
it must be installed in such a way as not to
be in contact with hot parts on the rear of the
appliance or kitchen. It must pass through an
area free of any hindrances and in a place
where it can be inspected along its entire length
(Fig. 2).
Fig. 1
Fig. 2
When the appliance is connected to the gas
supply, use soapy water to check for gas leaks.
The rubber hose must be connected as shown
in Fig. 3, 4 and 5, in compliance with local
applicable regulations
FOR FRANCE ONLY: install the conical fitting
(B) supplied on the appliance.
The maximum length of the rubber hose is
2 m. It must be a standard hose and must be
replaced within the date printed on it.
IMPORTANT: close the gas supply tap
i
before carrying out any maintenance
operation.
Connection details indicated in the injectors
table.
Fig. 3
26