Sub-Zero 424 Installation Manual page 22

Models 427 and 427R Installation
Lock Installation
For models 427 and 427R, the optional lock is attached
to the decorative door panel through a field-drilled hole in
the panel. The catch should be installed on the top of
appliance cabinet before the unit is moved into position.
The accessory lock kit and additional instructions are
available through your authorized Sub-Zero dealer, or call
Sub-Zero at 800-222-7820. You can also visit our website
at subzero.com.
IMPORTANT NOTE: For accessory stainless steel panels
requiring a lock, panels must be ordered with the lock
mounting hole pre-drilled.
Position the Unit
Remove the decorative top and side moldings and the
kickplate/grille of the wine storage unit.
IMPORTANT NOTE: If for any reason the wine storage unit
has been laid on its back or side, you must allow the unit
to stand upright for a minimum of 24 hours before con-
necting power.
Plug the power cord into the 15 amp grounded electrical
outlet. With power applied to the appliance, check for
lighting and cooling before going any further. Once you are
satisfied that the unit is operating properly, shut off power
to the electrical outlet at the circuit breaker and proceed.
Shut off the power to the electrical outlet.
If a home alarm system is to be used with the wine
storage unit, the lead wires should be threaded into the
compressor compartment before you position the unit.
Refer to wiring connections on page 24 for the location of
these lead wires. After the unit is in position, the alarm
wiring can be completed from the front.
Pre-level the wine storage unit before rolling into position.
This is to allow the unit to engage the anti-tip bracket
properly.
Roll the unit into position, making sure the anti-tip bracket
is engaged properly. Screw the front leveling legs out
3
approximately / " (5) to make any future adjustments
16
easier.
IMPORTANT NOTE: When the wine storage unit is
installed, the anti-tip bracket will be positioned just below
the engaging bracket on the unit. It is not necessary to
raise the unit up so that it locks into the anti-tip bracket,
but the unit must be in alignment with the anti-tip bracket.
IMPORTANT NOTE: The floor under the wine storage unit
must be at the same level as the surrounding finished floor
to allow for removal of the unit for servicing.
22