ECS EVEm Series User Manual page 29

Quick Power You can enable this item to shorten the power on
testing (POST) and have your system start up a
On Self Test
little faster. You might like to enable this item
after you are confident that your system
hardware is operating smoothly.
rd
1st/2nd/3 Use these three items to select the priority and
Boot Device order of the devices that your system searches
for an operating system at start-up time.
Boot Other If you enable this item, the system will search all
Device other possible locations for an operating system
if it fails to find one in the devices specified
under the first, second, and third boot devices.
Swap Floppy If you have two floppy diskette drives in your
Drive system, this item allows you to swap the
assigned drive letters so that drive A becomes
drive B, and drive B becomes drive A.
Boot Up If this item is enabled, it checks the geometry of
Floppy Seek the floppy disk drives at start-up time. You
don't need to enable this item unless you have an
old diskette drive with 360K capacity.
Boot Up This item defines if the keyboard Num Lock key
NumLock is active when your system is started.
Status
Gate A20 This item defines how the system handles legacy
Option software that was written for an earlier
generation of processors. Leave this item at the
default value.
Typematic If this item is enabled, you can use the following
Rate Setting two items to set the typematic rate and the
typematic delay settings for your keyboard.
Typematic If the item Typematic Rate Setting is enabled,
Rate you can use these items to define how many
(Chars/Sec)/ characters per second are generated by a held-
Delay (Msec) down key and how many milliseconds must
elapse before a held-down key begins generating
repeat characters.
3: BIOS Setup Utility
25