Shore Power Hook-Up - Monaco 2002 Diplomat Service Manual

The power requirement for the motorhome is 50 AMP 120/240 Volt AC
single phase. The shore cord is located in the roadside compartment. If 50-
amp shore power service is available, all that is necessary is to connect the
supplied shore power cord. If 50-amp service is not available, electrical
adapters will be required.
Plugging in the shore cord:
• Unscrew or open the deck plate then feed the cord
through the opening.
• If 50-amp service is not available, install the proper
electrical adapters to the cord.
• Always turn the shore power breaker off before con-
necting or disconnecting the shore cord. This will
prevent an accidental shock and flashing of con-
tacts.
• When the connection is made, turn the breaker on.
The transfer switch should make an audible click.
• Go inside the motorhome to check any available AC
Volt gauges to ensure proper voltage.
CAUTION: Avoid the risk of electrical shock or
component damage by disconnecting from shore
power during electrical storm activity. Use the
inverter or start the generator if AC power is
needed.
NOTE: Shown are the three types of shore power outlets
most commonly used.
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
D I P L O M A T
Electrical Systems - House
SHORE POWER
OM060121.eps
HOOK-UP
OM020125.eps
8 • 2 0 5