Manual Override Main Slide-Out - Monaco 2002 Diplomat Service Manual

Table of Contents

Advertisement

Equipment
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Manual Override
Main Slide-Out
OM030749.eps
5 • 1 3 8
• After the slide-out is all the way retracted, locate the two removable
locking bar mechanisms. Place the bar mechanisms between the wall
and the top edge of the slide-out room. The Lock'R has a built in spring
to preset the tension. Move the handle to lock the position.
NOTE: Be sure you have sufficient clearance on the inside of
the motorhome (driver seat, etc.) before you retract the slide-out
room. If your motorhome has ceramic tile floor ensure the
floor is clean before you retract the slide-out room. Dirt or
grit that is trapped under the slide-out room can scratch the
floor surface. Never move the motorhome without having the
slide-out room retracted.
To move the slide-out room manually retract the motorhome leveling
jacks (see "Leveling Jacks").
1. Open outside storage compartment doors underneath slide-out room.
2. Remove plastic covers, if applicable, from top of compartments to
gain access to drive shaft and drive mechanisms.
3. To move the slide-out room, move the lever on the motor counter-
clockwise to release motor brake and turn the end of the shaft next
to the gear box using a 7/8" wrench.
4. Once the room is in apply pressure to the wrench so that the room
is sealed. Return the brake lever to its normal position to lock the
room in place. Install the transit bar.
5. Take the motorhome to an authorized dealer for service.
NOTE: The slide-out room is heavy and may require several
persons to push it into the retracted position. Once the slide-out
room is in the fully retracted position, return the brake lever
to the lock position to hold the room in place.
Before operation of the slide-out system:
• The path for the room to move is clear.
• The battery is fully charged and hooked up to the electrical system.
• All storage compartment doors under the slide-out are closed.
• The slide locks are removed.
D I P L O M A T

Advertisement

Table of Contents
loading

Table of Contents