Parts Supplied - Pioneer AVIC-F700BT Operation Manual

( Connecting the System)
section
(~
)a
Parts supplied
Parts marked (*) are not supplied with AVIC-
F700BT and AVIC-F7010BT.
-
m
~
CO
-
iii"
:r
Power cord
The navigation unit
- Change the source from radio (AM or
FM) to another source.
- Turn the source off
- Turn off the ignition switch (ACC OFF)
• If [Ant CTRL] mode is set to [Power], the
vehicle's antenna can be stowed or turned
off only when the ignition switch is turned
off (ACC OFF).
• Do not connect this lead to the system con-
trol terminal of external power amps.
• Be sure not to use this lead as the power
supply lead for the auto-antenna or anten-
na booster. Such connection could cause
excessive current drain and malfunction.
Notice for the bluelwhite lead
• When the ignition switch is turned on (ACC
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control term-
inal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the audio source is switched off.
• Do not connect this lead to the auto-anten-
na relay control terminal or the antenna
booster power control terminal.
• Be sure not to use this lead as the power
supply lead for the external power amps.
Such connection could cause excessive
current drain and malfunction.
C!J
Connector*
Extension lead*
(for speed signal)
RCA connector
Extension lead
(for reverse signal)
GPS antenna
Microphone
En
m