Connecting The Power Cord - Pioneer AVIC-F700BT Operation Manual

section
m(
Connecting the System
)
(-----~)
Connecting the power cord (2)
"3 m (9 ft. 10 in.)
II
Note
The position of the speed detection circuit and the position of the
parking brake switch vary depending on the vehicle model. For details.
consult your authorised Pioneer dealer or an installation professional.
&WARNING
IMPROPER CONNECTION MAY RESULT IN SERIOUS DAMAGE
OR INJURY INCLUDING ELECTRICAL SHOCK, AND
INTERFERENCE WITH THE OPERATION OF THE VEHICLE'S
ANTI LOCK
BRAKING SYSTEM. AUTOMATIC TRANSMISSION
AND SPEEDOMETER INDICATION.
4
CAUTION
It is strongly suggested that the speed pulse wire be connected for
accuracy of navigation and better performance.
Pink (CAR SPEED SIGNAL INPUT)
This connection is unnecessary for AVIC-F700BT and AVIC-F701 OBT.
The mobile navigation system is connected here to detect the distance the
vehicle travels. Always connect the vehicle's speed detection circuit. Failure
to make this connection will increase errors in the location display.
...
Clamp firmly
with needle-
nosed pliers.
Close the cover.
Connection method
Pass the extension
~
cord and the lead for
~ the speed detection
J. circuit through this
hole.
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
l
~
_
Parking brake switch
Power supply Side
Ground side
Clamp the parking brake switch
power supply side lead.
...
Clamp firmly with needle-nosed
pliers.
Connection method
Light green
Used to detect the ON/OFF status of the parking brake. This lead must be
connected to the power supply side of the parking brake switch.
If this connection is made incorrectly or omitted, certain functions
A
of your navigation system
will
be unusable. ~
"WARNING - - - - - - - - - - - - - - ,
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST
Ir---"""'"'-------------
BE CONNECTED TO THE POWER SUPPLY SIDE OF THE
PARKING BRAKE SWITCH. IMPROPER CONNECTION
OR USE OF THIS LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS INJURY OR
DAMAGE.
En