Center Seat Latch; To Install A Latch-Compatible Child Restraint - Chrysler 2016 Town & Country Owner's Manual

112 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
anchorage and a way to tighten the connection to the
anchorage. Forward-facing child restraints and some
rear-facing child restraints will also be equipped with a
tether strap. The tether strap will have a hook at the end
to attach to the top tether anchorage and a way to tighten
the strap after it is attached to the anchorage.

Center Seat LATCH

If a child restraint installed in the center position blocks
the seat belt webbing or buckle for the outboard position,
do not use that outboard position. If a child seat in the
center position blocks the outboard LATCH anchors or
seat belt, do not install a child seat in that outboard
position.
Never use the same lower anchorage to attach more
than one child restraint. Please refer to "Installing
The LATCH-Compatible Child Restraint System" for
typical installation instructions.
Always follow the directions of the child restraint manu-
facturer when installing your child restraint. Not all child
restraint systems will be installed as described here.

To Install A LATCH-Compatible Child Restraint

If the selected seating position has a Switchable Auto-
matic Locking Retractor (ALR) seat belt, stow the seat
belt, following the instructions below. See the section
"Installing Child Restraints Using the Vehicle Seat Belt"
to check what type of seat belt each seating position has.
I n f o r ma t i o n P r o v i d e d b y :
WARNING!