Table of Contents
Advertisement
500 STARTING AND OPERATING
NOTE:
• When the parking brake is applied and the automatic
transmission is placed in gear, the "Brake Warning
Light" will flash. If vehicle speed is detected, a chime
will sound to alert the driver. Fully release the parking
brake before attempting to move the vehicle.
• This light only shows that the parking brake is ap-
plied. It does not show the degree of brake application.
When parking on a hill, it is important to turn the front
wheels toward the curb on a downhill grade and away
from the curb on an uphill grade. For vehicles equipped
with an automatic transmission, apply the parking brake
before placing the shift lever in PARK, otherwise the load
on the transmission locking mechanism may make it
difficult to move the shift lever out of PARK. The parking
brake should always be applied whenever the driver is
not in the vehicle.
• When leaving the vehicle, always remove the Key
Fob from the ignition and lock your vehicle.
• Never use the PARK position as a substitute for the
parking brake. Always apply the parking brake
fully when parked to guard against vehicle move-
ment and possible injury or damage.
• When leaving the vehicle, always remove the
Key Fob from the ignition and lock your vehicle.
If equipped with Keyless Enter-N-Go, always
make sure the keyless ignition node is in "OFF"
mode, remove the Key Fob from the vehicle and
lock the vehicle.
I n f o r ma t i o n P r o v i d e d b y :
WARNING!
(Continued)
Advertisement
Table of Contents
