To Turn Off The Engine While In Remote Start Mode; When To Reset Remote Start - Chrysler 2016 Town & Country Owner's Manual

Hide thumbs Also See for 2016 Town & Country:
Table of Contents

Advertisement

• The engine is allowed to run for the entire 15-minute
cycle.
To Turn Off The Engine While In Remote Start
Mode
Push and release the REMOTE START button one time or
allow the engine to run for the entire 15 minute cycle.
NOTE: To avoid unintentional shutdowns while in the
Remote Start Mode, the system will not allow the Remote
Start button to shut down the engine for two seconds
after receiving a valid Remote Start request.

When To Reset Remote Start

The vehicle can be started remotely up to a maximum of
two times. The vehicle is also allowed a maximum of one
failed start, where the Remote Starting sequence was
initiated but the engine stopped cranking without start-
ing. After either of these conditions, or if the Vehicle
Security Alarm system is alarming, or if the PANIC
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 35
button was pushed, the vehicle must be reset by cycling
the START/STOP button to the ON/RUN position.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired op-
eration.
NOTE: Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
I n f o r ma t i o n P r o v i d e d b y :
2

Advertisement

Table of Contents
loading

Table of Contents