Surround Panel Installation - Lopi Answer Owner's Manual

O
PTIONAL
P 40
AGE
S P
URROUND ANEL
Surround panel size is determined by the type of installation and the size of the fireplace opening.
Direct and positive connections do not require insulation or panels that overlap the fireplace opening
(panels that overlap the fireplace opening are usually more attractive). Face seal connections require
surround panels that overlap the fireplace opening on the top and sides at least 2" (2 1/2" for rough
surfaces). This overlap is needed for the insulation that forms the airtight seal between the surround
panels and the fireplace. Any questions on selection of the surround panels should be directed towards
your dealer. The table below details the size of the surround panels when installed.
SURROUND PANEL SIZE
8"
10"
The surround panels should be installed prior to installing the insert. Place the insert 12" from the
fireplace opening while installing the surround panels.
1. Remove the two button plugs from each side of the insert (see illustration below).
2. Using a 5/16" nutdriver or large screwdriver, screw the thread-cutting screws into the four holes
exposed by removing the button plugs. The holes are now pre-threaded, remove the screws.
3. Place the right side panel so the holes on the panel align with the holes on the insert. Attach the
panel with the thread-cutting screws, leaving the screws loose enough to adjust the side panel.
Repeat for the left side.
4. The top panel has four joggle clips that slide over the offset portion on top of the side panels.
The best way to insert the top panel is to hold it at an angle and insert one side first and gradually
lower it until the opposite side is inserted. Adjust the top panel so its edges are flush with the
side edges of the side panels.
5. Adjust the position of the side panels so they are: 1) flush with the bottom of the insert; 2) both
the same distance back from the front of the insert; 3) perpendicular to the floor. Tighten the
screws that hold the side panels in place.
NOTE: If using a positive or direct connection, remove the top panel to attach the flue.
Side Panel
E (C
QUIPMENT
I
NSTALLATION
(S
EE TABLE BELOW FOR PART NUMBER
SIZE ON APPLIANCE (Including Trim)
40 1/8" width by 28 1/4" height
44 1/8" width by 30 1/4" height
Top Panel
)
ONTINUED
Side Panel
)
PART #
99300106
99300107
The joggle clips on the top
panel slide over the offset
portion on top of the side
panels.
Remove the button plugs
located here. Use the
thread cutting screws to
attach the side panel.
Use two thread cutting
screws to attach each
side panel.