O
PTIONAL
P
42
AGE
T
L
ELESCOPING
EG
The telescoping legs are designed to support the front end of fireplace inserts on raised hearths. It is
adjustable from 4 5/8" to 7 1/2". It can be cut shorter by using a hacksaw (see the illustration below).
1. Place the end caps into each lower segment of the telescoping legs (see the illustration below).
2. Screw the telescoping legs together so the leg can be screwed into the bottom of the insert. Hand
tighten the telescoping leg into position.
3. While grasping the upper segment of the telescoping leg, unscrew the bottom segment until it
reaches the floor and supports the insert.
E
(C
QUIPMENT
I
NSTALLATION
(P
ART NUMBER
Install the
telescoping leg
by tightening
the threaded rod
at the top of the
upper segment
into the bottom
of the insert.
Adjust the
length of the
telescoping leg
by rotating the
lower segment.
)
ONTINUED
99200120)
If the telescoping leg needs to be less than 4 5/8", a hack saw
can be used to shorten its length. Seperate the two segments
and shorten both segments by cutting them with a hack saw.
The upper segment has a threaded rod inside. Do not damage
this rod while shortening the upper segment.
NOTE: The total length removed will equal the amount cut off of
both segments combined.