Section 10. Electronic Control Model 10·1; Operating Instructions - Maytag Jenn-Air Service Manual

SECTION 10. ELECTRONIC CONTROL MODEL
This section details only the components
and service procedures that are unique to
the Electronic Control Washer. There-
fore, it must be used in conjunction with
the remainder of the service manual to
provide a complete service program for
these models.
OPERATING INSTRUCTIONS
1. LOAD BLEACH DISPENSER - if de-
sired {maximum one cup}.
2. MEASURE DETERGENT - place in
washer basket.
3. LOAD CLOTHES - loosely in washer.
Maximum load is to top vanes of
agitator.
4. LOAD LIQUID DISPENSER - if de-
sired. Fabric softener with regular
cycles or liquid detergent with
STAIN-CLEANER cycles. Clean be-
tween uses.
5. CLOSE LID
6. PUSH START - This activates the
washer and allows time for you to
make selections.
7. SELECT CYCLE - The permanent
press cycle has been pre-selected.
This means that regular agitation/
slow spin speeds, warm wash/cold
rinse, and super water level lights
will glow. If START is pressed, the
washer will proceed through the
Permanent Press
cycle. If this is not
the cycle desired, choose cycle
which best describes the type of
fabric to be washed. Then press
cycle chosen. The proper wash
and spin speeds as well as the
water temperature are automatic-
ally provided and indicated. If
different speeds, water level or
temperature is desired, use
Manual
Options.
Indicator lights will glow
when selection is made. The washer
will beep when selections cannot
be made.
8. WATER LEVEL - PRESET OR SUPER
To change, touch LEVEL until desired
setting is shown. Determine setting
based on load size
{see table below}.
Selection should provide sufficient
water to permit clothes to circulate
during agitation.
It may become necessary, due to
bulky fabrics, to adjust the water
level after agitation begins. To adjust
for higher water level in wash, touch
OFF then reactivate unit and make
new selection.
{Steps
6
thru
9}. If
higher or lower water level is desired
only in rinse, touch LEVEL until desired
water level is selected. Machine will
automatically go to that level for rinse.
Water Saver Dry Weight (Kilograms)
Control of Clothes
Setting (Per Pound)
Super 12 - 22
(5.4 to 10)
High
6 - 12
(2.7 to 5.4)
Medium 2- 6 (0.9 to 2.7)
Low 2 or Under (0.9 )
9. TO START - PUSH START/PAUSE
You may stop the washer at any
time. Push PAUSE to remain in the
16007667 SECTION 10. ELECTRONIC CONTROL MODEL
10-1
©
1996 Maytag Corporation