Connect the power cable.
6.
Install the access panel.
7.
Install the server into the rack
8.
Connect each power cord to the server.
9.
Connect each power cord to the power source.
10.
Drive option
When adding hard drives to the server, observe the following general guidelines:
•
The system automatically sets all device numbers.
•
If only one hard drive is used, install it in the bay with the lowest device number.
•
Hard drives must be SFF types.
Drives should be the same capacity to provide the greatest storage space efficiency when drives are grouped
together into the same drive array.
For drive numbers, see "Drive bay numbering (on page 20)."
To install the component:
Remove the drive blank.
1.
("Installing the server into the
rack" on page 41).
Hardware options installation 71