Stihl TS 480i Instruction Manual page 29

Insert the square nut into the guide
N
in the guard and hold it in place
Screw in the shorter banjo bolt (6)
N
and washer at the adjusting lever
and tighten up with the combination
wrench
Mounting "cast arm with guard" – guard
on the outboard side
1
2
1
1
2
2
3
4
Press the oblong holes (1) in the
N
"cast arm and guard" on to the
studs (2), guiding the ribbed V-belt
over the front pulley
NOTICE
The belt action must run smoothly.
The belt tensioner (3) must sit close
N
to the lug (4)
TS 480i, TS 500i
2
2
2
6
5
6
6
Fit the "starter cover with rewind
N
starter" (5) over the studs (2)
Tighten up the nuts (6) by hand
N
7
8
Push the V-belt guard (7) into place
N
Screw in the bolt (8) and tighten up
N
Connecting the water connection
3
1
2
1
Insert the longer banjo bolt (1)
N
through the connector (2) of the
water attachment – observe the
position of the connector
Insert the square nut into the guide
N
in the guard and hold it in place
Fit the support with the longer banjo
N
bolt on the adjusting lever (3) –
screw in the banjo bolt and tighten
with the combination wrench
Insert the water hose into the guide
N
in the V-belt guard (arrow) from the
water connection towards the guard
– avoid tight radiuses
Checking the adjustment range of the
guard
Rotate the guard forwards and
N
backwards as far as possible –
adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter
"Tensioning the V-belt".
English
A
27