Stihl TS 480i Instruction Manual page 10

English
WARNING
Before use, make sure that the fuel cap
has been completely and properly
tightened and any spilled fuel wiped
away. Check for fuel leakage while
refueling and during operation. If a fuel
leak is suspected, do not start or run the
engine until the leak is fixed and spilled
fuel has been wiped away.
Before Starting
For wheel installation, follow the
procedure described in the appropriate
sections of your instruction manual.
Check the fuel system for leaks by
turning the machine in all operating
positions and inspecting all relevant
parts of that system that are visible, e.g.,
filler cap, hose connection, fuel pump
and tank. Do not start the unit if there are
leaks or damage to the fuel system – risk
of fire! Have the machine repaired by a
servicing dealer before using it.
Never operate a cut-off machine that is
damaged, improperly adjusted or not
completely and securely assembled.
Check machine that it is ready for proper
operation.
Keep the handles dry, clean and free of
oil and fuel.
WARNING
Before operation of your cut-off
machine, be sure the controls (e.g.
throttle trigger, throttle trigger lockout,
stop switch) and the safety devices are
working properly, the wheel is properly
mounted, and the wheel guard is in
8
place and securely fastened to your unit.
All wheels should be carefully inspected
for good condition before mounting.
Adjust the wheel guard
so that sparks, dust and
cut material are deflected
away from the operator,
and cannot reach flam-
mable surroundings. See
section "Operating
Instructions" of your
instruction manual.
WARNING
Check that the spark plug boot is
securely mounted on the spark plug – a
loose boot may cause arcing that could
ignite combustible fumes and cause a
fire.
Proper tensioning of the ribbed V-belt is
important. In order to avoid an incorrect
setting, the tensioning procedure must
be followed as described in your
manual. Always make sure the
hexagonal collar nuts for the cast arm
are tightened securely.
Check ribbed belt tension after one hour
of operation and correct if necessary.
Starting
WARNING
Your cut-off machine is a one-person
tool. Do not allow other persons to be
near a running cut-off machine. Start
and operate your cut-off machine
without assistance. For specific starting
instructions, see the appropriate section
of your instruction manual.
Do not drop start. This method is very
dangerous because you may lose
control of the cut-off machine. Place the
cut-off machine on firm ground or other
solid surface in an open area. Maintain
good balance and secure footing. Be
absolutely sure that the cutting wheel is
clear of you and all other obstructions
and objects, including the ground. When
the engine starts at starting position,
engine speed will be fast enough for the
clutch to engage the belt pulley and turn
TS 480i, TS 500i