Parts Lists - WAGNER Project 115 0418A Owner's Manual

Figure 20 - Cleaning the Inlet Valve (Kit part number
0418714)
Cleaning or servicing the inlet valve may be required if
i
the unit has priming problems. Priming problems may
be prevented by properly cleaning the sprayer and
following the long-term storage steps.
Perform the Pressure Relief Procedure (see figure 7) and
unplug the sprayer.
Danger
1. Remove the hopper. Loosen the locknut by turning
anticlockwise.
2. Remove the inlet sleeve (1) with a suitable tool (e.g. socket SW
11).
3. Inspect the threads on the inlet sleeve and the inlet sleeve
O-ring (2). Remove any accumulated paint.
4. To remove the inlet valve, place the assembly aid (8) on a
socket (6) with a 5/8" insert (7). Insert the inlet valve tool into
the inlet valve (a). Remove the inlet valve screw connection by
unscrewing anticlockwise from the housing.
5. Retrieve the inlet valve (9) and the inlet valve O-ring (10) from
the inlet valve housing. Clean or replace and lubricate the
O-ring with a light household oil.
6. Set the inlet valve O-ring (10) back into the housing, and set
the inlet valve (9) on top of it.
7. Replace inlet fitting (8) into the housing. Tighten with the
inlet valve tool (7) and ratchet (4, 5, 6).
8. Replace the seal (3). Place the inlet sleeve O-ring (2) onto
the inlet valve fitting (9), and replace the inlet sleeve (1) by
twisting it clockwise.
9. Replace the hopper.
Figure 21 - Cleaning the Outlet Valve
Cleaning or replacing the outlet valve may be necessary if your
spray performance remains poor after having performed all the
steps contained in the Troubleshooting section of this manual.
Perform the Pressure Relief Procedure (see figure 7) and
unplug the sprayer.
Danger
1. Unscrew the outlet valve from the outlet valve housing using
an adjustable wrench.
2. Inspect the inside of the outlet valve housing (a). Clean any
accumulated paint.
3. Replace with a new outlet valve. Tighten into outlet valve
housing with an adjustable wrench.
Wagner Project 115 - 0418A

Parts Lists

Figure 22 - Spray Gun/Spray Hose
Item Part # Description
1 0418717 Gun assembly (without nozzle ) ....................1
2 0418705 Tip, XS ......................................................................1
2 0418707 Tip, M .......................................................................1
3 0418711 Filter, XS-S (red) ...................................................2
3 0418712 Filter, M (yellow) ..................................................2
4 0418718 Spray hose, 7.5m, red ........................................1
Part # Description
0418705 Spray tip, XS .....................Water-soluble and solvent
0418706 Spray tip, S .......................Synthetic resin-based paints,
0418707 Spray tip, M ......................Enamel paints, undercoats,
0418708 Spray tip, L .......................Enamel paints, undercoats,
0418711 Filter, XS - S (red, 2 pack)
0418712 Filter, M (yellow, 2 pack)
0418713 Filter, L - XXL+ (white, 2 pack)
0418714 Valve set (inlet and outlet valve)
All spare parts listed above are wear parts, and are not covered
by warranty!
18
Quantity
based enamels and paints, oils
and release agents
PVC paints
primers, fillers, indoor latex
paints and indoor emulsions
primers, fillers, indoor latex
paints and indoor emulsions,
anti-corrosive paints