Editing Tcp/Ip Options (With Pptp Encapsulation) - ZyXEL Communications ZyWALL 10 User Manual

Field
Private
RIP
Version
Multicast
Once you have completed filling in the Network Layer Options Menu, press [Enter] to return to
Menu 11. Press [Enter] at the message [Press ENTER to Confirm...] to save your configuration, or
press [Esc] at any time to cancel.

4.2.1 Editing TCP/IP Options (with PPTP Encapsulation)

Make sure that Encapsulation is set to PPTP in Menu 11.1. Then move the cursor to the Edit IP field in
Menu 11.1, press the [SPACE BAR] to toggle No to Yes. Press [Enter] to open Menu 11.3 - Network
Layer Options.
Remote Node Setup
between 1 and 15. In practice, 2 or 3 is usually a good number.
This field is valid only for PPTP/ PPPoE encapsulation.
parameter determines if the ZyWALL will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
Press the [SPACE BAR] to select the RIP direction from Both/
None/In Only/Out Only. Please see section 3.1.4 for more
information on RIP. The default for RIP on the WAN side is None. It
is recommended you do not change this setting.
Press the [SPACE BAR] to select the RIP version from RIP-1/RIP-
2B/RIP-2M and None.
IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The ZyWALL
supports both IGMP version 1 (IGMP-v1) and IGMP-v2. Press the
space bar to enable IP Multicasting or select None to disable it. See
the previous Part for more information on this feature.
ZyWALL 10 Internet Security Gateway
Description Example
Yes
This
None
IGMP-v2
4-7