Figure 6-9 Editing An Individual Rule In A Set; Table 6-6 Menu 15.1.1.1 - Configuring An Individual Rule - ZyXEL Communications ZyWALL 10 User Manual

Select Rule
N.B.: Save Set in the Action field means to save the whole set. You must do this if you
make any changes to the set – including deleting a rule. No changes to the set take
Be careful when ordering your rules as each rule is executed in turn beginning from
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 -
Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global
Start/End IPs displayed in Menu 15.1.1.
Press Space Bar to Toggle.
The following table describes the fields in this screen.

Table 6-6 Menu 15.1.1.1 - Configuring an Individual Rule

Field
Type
NAT
selected. The rules after the selected rule will then be
moved down by one rule. Delete means to delete the
selected rule and then all the rules after the selected
one will be advanced one rule. Save Set means to
save the whole set (note when you choose this action,
the Select Rule item will be disabled).
When you choose Edit, Insert Before or Delete in the
previous field the cursor jumps to this field to allow you
to select the rule to apply the action in question.
place until this action is taken.
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Press ENTER to Confirm or ESC to Cancel:

Figure 6-9 Editing an Individual Rule in a Set

Press the [SPACEBAR] to toggle through a
total of 5 types. These are the mapping
types discussed above (see
Type Server allows us to specify multiple
servers of different types behind NAT to this
ZyWALL 10 Internet Security Gateway
rule 1.
Description
Table 6-2
Save Set
Option/Example
One-to-One
Many-to-One
Many-to-Many
).
Overload
Many-to-Many No
6-11