Quadra-Fire MTVERNINSAE-MBK Owner's Manual page 32

Mt. Vernon Pellet Insert (AE)
SETTING COMFORT LEVEL
READY 12:30 PM
Set at: 68
71
MENU HEAT OUTPUT
1. Press and hold "UP" or "DOWN" but-
ton to set desired temperature.
NOTE: Set temperature must be 3
degrees higher than room
temperature for appliance to
start.
74 ºF
2. Press "HOLD TEMP".
SET COMFORT LEVEL
74 ºF
ON HOLD
DONE RESUME
3. Press "DONE".
Page 32
SETTING HEAT OUTPUT
READY 12:30 PM
Set at: 74
Hold at:
71
MENU HEAT OUTPUT
1. At the starting screen, press "HEAT
OUTPUT".
Medium High
2. Use the "UP" button to change "HEAT
OUTPUT LEVEL" to "MEDIUM-HIGH".
3. Press "DONE" twice or wait 15 seconds
for starting screen to re-appear.
7036-135G
HOPPER OUT OF FUEL
ERROR LIST
Min Firepot Temp
RETRY
1. If the appliance has stopped operat-
ing, check the wall control screen. If
it is showing "Min Firepot Temp" the
hopper has run out of fuel.
2. Fill the hopper with fuel and press the
"RETRY" button twice. The fi rst time
turns on the back light, the second
time starts the retry function.
12:30 PM
SHUTDOWN
Hold at: Set at: 74
71
MENU
HEAT OUTPUT
3. If the wall control screen changes to
a "SHUTDOWN" screen that means
your appliance has not completed the
full shutdown cycle. Depending on
where it was in the cycle it can take
from one to ten minutes to restart.
When the shutdown cycle is complete
the wall control screen will display
"STARTUP". Continue to Step 4.
STARTUP 12:30 PM
Hold at: Set at: 74
71
MENU
HEAT OUTPUT
4. If the wall control screen changes to
a "STARTUP" screen after pressing
"RETRY" that means your appliance
has already completed the shutdown
cycle. You must wait until the wall con-
trol screen displays the startup screen
and then put 1/2 cup of pellets in the
fi repot for a quick restart.
5. Be sure the hopper lid and glass door
are both closed.
November 22, 2011
R
SERVICE