Setting The Cleaning Level; After Self-Cleaning; Care And Cleaning; Cleaning Agents - Siemens HB78GB.90B Instruction Manual

Hide thumbs Also See for HB78GB.90B:
Table of Contents

Advertisement

Non-enamelled accessories, e.g. the wire rack, are not suitable
for the self-cleaning programme. Remove them from the
:
cooking compartment.
Risk of serious damage to health.!
Never clean non-stick baking trays and baking tins at the same
time using the self-cleaning programme. High temperatures
damage the non-stick coating and poisonous gases are
released.
Note: For details on which accessories are suitable for the self-
cleaning programme, please see the optional accessory table
at the start of these instructions.

Setting the cleaning level

V
1.
Press the
button.
Cleaning level 3 is suggested. You can start the self-cleaning
immediately by pressing the
If you wish to change the cleaning level:
Select the desired cleaning level using the rotary selector.
2.
Start the cleaning operation with
3.
The oven door locks shortly after operation starts. The
symbol lights up to indicate that the lock has been activated.
The oven door will not open again until the symbol goes out.

Care and cleaning

With good care and cleaning, your oven will remain clean and
fully-functioning for a long time to come. Here we will explain
how to maintain and clean your oven correctly.
Notes
Slight differences in the colours on the front of the oven are
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, a
Shadows on the door panel which look like streaks,
Shadows on the door panel which look like streaks, are
caused by reflections made by the oven light.
Enamel is baked on at very high temperatures. This can
Enamel is baked on at very high temperatures. This c
Enamel is baked on at very high temperatures. This
cause some slight colour variations. This is normal and does
cause some slight colour variations. This is normal and does
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
not affect their function. The edges of thin trays cannot be
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
completely enamelled. As a result, these edges can be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
rough. This will not impair the anti-corrosion protection.
rough. This will not impair the anti-corrosion protection.

Cleaning agents

To ensure that the different surfaces are not damage
To ensure that the different surfaces are not damage
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
the wrong cleaning agent, observe the information in the table.
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
cleaning agents with a high concentration of alcohol,
hard scouring pads or sponges,
high-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Area
Cleaning agents
Oven front
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Do not use glass cleaners or
glass scrapers.
button.
.
H
are
re
can
an
Once cleaning has finished
The oven stops heating. "Self-cleaning finished" appears in the
status bar.
Cancelling cleaning
H
Switch the oven off with the
door until the
symbol disappears.
Adjusting the cleaning level
Once cleaning starts, the cleaning level can no longer be
changed.
Setting cleaning to run overnight
So that you can use your oven throughout the day, delay the
end of the cleaning process to during the night. See the Time-
setting options section, setting a later end time.

After self-cleaning

Once the cooking compartment has cooled down, wipe out the
ash that has been left behind in the cooking compartment with
a damp cloth.
Area
Cleaning agents
Stainless steel
Stainless steel
Stainless steel
Hot soapy water:
Hot soapy water:
Hot soapy water:
Clean with a dish cloth and dry with a
soft cloth. Remove flecks of limescale,
grease, starch and albumin (e.g. egg
white) immediately. Corrosion can form
under such residues.
Special stainless steel cleaning prod-
ucts suitable for warm surfaces are avail-
able from our after-sales service or from
specialist retailers. Apply a thin layer of
the cleaning product with a soft cloth.
Door panels
Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Door cover
Stainless steel cleaning agents (available
from our after-sales service or from spe-
cialist retailers):
Please observe the manufacturer's
instructions.
Cooking compart-
Hot soapy water or a vinegar solution:
ment
Clean with a dish cloth.
If there are heavy deposits of dirt, use a
stainless steel scouring pad or oven
cleaner. Only use when the cooking
compartment is cold.
It is best to use the self-cleaning function.
Observe the instructions in the Self-clean-
ing section when doing so.
Glass cover for the
Hot soapy water:
oven light
Clean with a dish cloth.
Shelves
Hot soapy water:
Soak and clean with a dish cloth or
brush.
button. Do not open the oven
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents