Download Print this page

Before Using The Warming Drawer; Appliance Fitting - KitchenAid KSDX 1440 User Instructions

Advertisement

Before using the warming drawer

To open and close the drawer, in the version without
handle, push the center of the panel as shown in the
figure, whereas, for the version with handle, pull and
guide the panel by the handle.
At first use, clean the appliance as follows:
- clean the surface with a damp cloth and then dry.
- Preheat the empty drawer for at least two hours: turn
the temperature knob to maximum or select the maximum temperature, to eliminate any residuals of fat,
oil or manufacturing resins that can create unpleasant odors during the warming of dishes. Air the room.
- After completing these operations, the appliance is ready for first use.
• Before use, remove:
- stickers placed on the front and door of the warming drawer, except the rating plate;
- all the cardboard protection or plastic film from all aesthetic and other parts, on the outside and inside
the appliance;
- any stickers from accessories when present.

Appliance fitting

Safety instructions for fitting the drawer
IMPORTANT: The drawer must be immediately fixed to the cabinet, following the instructions given
below. The coupled appliance cannot be installed before fixing the drawer to the cabinet.
This appliance must only be fitted and installed by qualified personnel who ensure conditions for its
safe use.
Fix the drawer as shown in the figure
Before electrically connecting the appliance, make sure the rating plate data matches the mains power
supply, otherwise the appliance could
become damaged.
Make sure the connection to the power
supply is easily accessible after the appliance
has been fitted.
The dish warmer can only be fitted in
combination with other appliances not
weighing more than 60 kg and provided with
adequate cooling ventilation.
To install the appliance that can be combined with the dish warmer, follow the instructions given in the
relevant use and installation handbook.
Important: The coffee maker or combi microwave oven of the same brand and sized as shown on the
following page, can be installed above the dish warmer.
For installation, carefully follow the directions given in the instruction handbooks supplied with the coffee
maker and the combi microwave oven.
Fitting dimensions
The size of the recess is obtained from the size of the dish warmer plus the size of the appliance combined
with it. All measurements are in mm.
6

Advertisement

loading