Download  Print this page

Installationinstructions; Install Warming Drawer - KitchenAid KEWS105SSS03 Installation Instructions Manual

24" (61 cm), 27" (68.6 cm), and 30" (76.2 cm) indoor/outdoor electric warming drawer
Hide thumbs
   

Advertisement

INSTALLATIONINSTRUCTIONS
7. Slowly push against the front panel and slide the drawer
completely into the cabinet until the flanges on the front panel
meet the cabinet face.
8. Use the four #8-18 x %" screws provided to secure the
warming drawer frame to the cabinet.
Excessive
Weight Hazard
Use two or more people to move and install
warming drawer.
Failure to do so can result in back or other injury.
1. Turn off power supply. Using 2 or more people, move warming
drawer close to its final location. Remove and discard
shipping materials, tape, and protective film from the warming
drawer. Remove and set aside racks and other parts from
inside warming drawer.
2. Remove the drawer:
Pull drawer to its fully open position. Press tab down on
right-hand side and lift tab upward on left, then slide
drawer out about 1" (2.5 cm).
/
Slowly remove the drawer from the slides, holding on to
the sides, not the drawer front.
Set drawer aside on a covered surface.
3. Make sure the that the warming drawer Temperature control
knob is set to the OFF position.
4. Support the warming drawer on a sturdy surface level with the
cutout opening.
EmectricaI Shock Hazard
Plug into a grounded
3 prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions
can result in death,
fire, or emectrica{ shock.
g.
A. Four #8-18 x %" screws
Replace the drawer by aligning the drawer guides with the
receiving slides. Push drawer in completely.
A. Receiving slides
10. Slowly open and close drawer to ensure it is seated properly
on both sides.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials.
4. For warming drawer use and cleaning, read the Use and Care
Guide.
5. Turn the Temperature control knob to HI, and the red light
should illuminate.
If warming
drawer(s) does not operate,
check the
following:
Household fuse is intact and tight; or circuit breaker has not
tripped.
Warming drawer is plugged in and, electrical supply is
connected.
If you need Assistance
or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your warming drawer.
5. Plug the power supply cord into the grounded 3 prong outlet.
6. Slide the warming drawer over half way into the cutout
opening.

Advertisement

Table of Contents
loading

  Related Manuals for KitchenAid KEWS105SSS03

This manual is also suitable for:

Kews105spa03Kews175spa03Kews175sss03Kews145sss03Kews145sss02Kews175spa02 ... Show all