Secure The Oven To The Cabinetry - DCS WOSU30 Installation Instructions Manual

ELECTRICAL CONNECTION TO JUNCTION BOX
8
Junction box location
for: undercounter
installation
Junction box
location for:
wall installation
Disconnect the power supply.
1
Remove the junction box cover.
2
Connect the oven cable to the junction box
3
through the U.L.-listed conduit connector.
Connect the two black wires together with
4
twist-on connectors.
Connect the two red wires together with
5
twist-on connectors.
Connect electrical connection according to
6
local codes and ordinances.

SECURE THE OVEN TO THE CABINETRY

9
1 Position the oven in the prepared cavity.
Important!
Do not lift the oven by the door handle.
2 Use the supplied screws and spacers to secure the oven to the cabinetry.
Double oven models only:
There are 4 screws and spacers provided (two per side).
Important!
Do not over-tighten the screws.
Take care not to damage the lower trim of the oven.
Do not seal the oven into the cabinetry with silicone or glue. This makes future
servicing difficult. DCS by Fisher & Paykel will not cover the costs of removing the
oven, or of damage caused by this removal.
OB30 Single
Max. current draw: 19.4 A
Nameplate
Max. load: 4.6 kW
OB30 Double
Max. current draw: 38.3 A
Max. load: 9.2 kW
If local codes permit connecting the cabinet-
grounding conductor to the neutral white wire
in the junction box:
Connect the factory-taped green and white oven
7a
cable wires to the neutral (white) wire in the
junction box.
Replace the junction box cover.
8a
red wires
white and green
grounding oven
wires - factory
taped
OR
If local codes DO NOT PERMIT
connecting the cabinet-grounding
conductor to the neutral (white) wire in
junction box:
Separate the factory-taped green and white
7b
oven cable wires.
Connect the white oven cable wire to the
8b
neutral (white) wire in junction box.
Connect the green grounding oven cable
9b
wire to a grounded wire in the junction box.
Replace the junction box cover.
10b
cable from
red wires
power supply
box
black
wires
green grounding
oven wires
UL - listed conduit
UL - listed
- factory taped
connector
conduit connector
OR
If connecting to a four-wire electrical
system:
Separate the green and white oven cable wires.
7c
Connect the white oven cable wire to the
8c
neutral (white) wire in junction box.
Connect the green grounding oven cable wire
9c
to the (green) grounding wire in the junction
box.
Do not connect the green grounding wire to
the neutral (white) wire in junction box.
Replace the junction box cover.
10c
Ensure supplied
spacer is fitted
between oven
and cabinetry
9
cable from
power supply
box
white
wires
black
wires