The Vrrp Is Not In The Master State On The Primary Or Secondary Device; Dcpdp Does Not Detect The Peer - NETGEAR ProSAFE M5300 Series Software Administration Manual

Web Interface: Check the Accept Mode
1. Select Routing > VRRP > Advanced > VRRP Configuration.
A screen similar to the following displays.
2. Under Global Configuration, next to Accept Mode, select the Enable radio button.
3. Click Apply.
The VRRP Is Not in the Master State on the Primary or
Secondary Device
If the state of VRRP is Initialize (for example, the VRRP on VLAN 300), check the following:
1. Check if the peer link is up. If it is not, get up the peer link.
2. Check if the MLAG is member of VLAN 300. If it is not, add the MLAG to the VLAN.
(M7100-24X) #show ip vrrp interface brief
Interface VRID
--------- ----
vlan 100 1
vlan 200 1
vlan 300 1

DCPDP Does Not Detect the Peer

If the Dual Control Plane Detection Protocol (DCPDP) does not detect the peer, check the
following:
1. Check if DCPDP is enabled in the VPC domain.
2. If DCPDP is enabled, check the destination IP address, source IP address, and port
number. of the DCPDP.
3. Ping the destination address of the DCPDP to verify that it is reachable.
Managed Switches
IP Address Mode
-------------- ------
192.168.100.3 Enable
192.168.102.3 Enable
192.168.103.3 Enable
MLAGs
101
State
------------
Master
Master
Initialize