Access The Web Management Interface When The Switch Is Already Connected To The Network - NETGEAR M6100 Series Software Setup Manual

12. Select System > Management > IPv4 Service Port.
13. Select the Service Port Configuration Protocol None radio button.
14. In the IP Address field, enter the service port IP address.
For example, enter 172.26.1.110.
15. In the Subnet Mask field, enter the service port subnet mask.
For example, enter 255.255.255.0.
16. In the Default Gateway field, enter the service port default gateway.
For example, enter 172.26.1.1.
17. Click the Apply button.
Your settings are saved.
18. Log out of the web management interface.
19. Return your computer to its original settings.
If you want log in to the web management interface again, you now must use the newly
assigned network IP address.
Access the Web Management Interface When the Switch Is
Already Connected to the Network
This procedure describes how to access the web management interface when you already
configured the management VLAN IP address of the switch.
To access the web management interface:

1. Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port
on the switch.
2. Launch a web browser such as Google Chrome, Mozilla Firefox, or Microsoft Internet
Explorer.
3. Enter the management VLAN or service port IP address of the switch in the web browser
address field.
M6100, M5300, and M7100 Series Switches
Get Started
18