NETGEAR ProSAFE M5300 Series Software Administration Manual page 481

2. After Switch A reboots, check the stack port configuration.
(Netgear Switch) #show port 2/0/28
Admin
Intf Type Mode
------ ----- -------
2/0/28 Enable
3. On Switch B, configure the stack port and reboot the switch.
(Netgear Switch) #
(Netgear Switch) #show stack-port
Unit Intf SlotId Type
---- ----- ------ ------
1 0/51 AX742
1 0/52 AX741
(Netgear Switch) #config
(Netgear Switch) (Config)#stack
(Netgear Switch) (Config-stack)#stack-port
(Netgear Switch) (Config-stack)#exit
(Netgear Switch) (Config)#exit
(Netgear Switch) #reload
Are you sure you want to reload the stack? (y/n) y
4. After Switch B reboots, check the stack port configuration.
(Netgear Switch) #show port 2/0/28
Admin
Intf Type Mode
------ ----- -------
1/0/51 Enable 10G Full 10G Full
Managed Switches
Physical Physical
Mode Status
-------- ---------
10G Full 10G Full
Configured Running
Stack
XFP Adapter Mode
----------- -------
(stack) Ethernet
Ethernet
Physical Physical
Mode Status
-------- ---------
Up
Switch Stacks
481
Link Link LACP
Status Trap Mode
------ ------- -------
Up Enable Enable
Stack Link
Mode Status
------ -----
Ethernet Link Down
Ethernet Link Down
1/0/51 ethernet
Link Link LACP
Status Trap Mode
------ ------- ------
Enable Enable long
Actor
Timeout
------
long
Link
Speed
(Gb/s)
-----
12
10
Actor
Timeout
------