VTech ErisTerminal VSP600 Administrator And Provisioning Manual page 20

To set static IP for the VSP600:
1. From the Network setting menu, press
press MENU/SELECT.
If DHCP is disabled, the Set static IP menu appears. If DHCP is enabled, an error
message appears briefly before returning you to the Network setting menu.
2. On the Set static IP menu, enter the static IP address. Use the dial pad to enter
characters. To add a period, press the * key.
Set static IP
IP Address:
0.0.0.0
Subnet Mask:
0.0.0.0
BACK
3. Press
4. Press
5. Press
To set the VLAN ID for the VSP600:
1. From the Network setting menu, press
press MENU/SELECT.
2. On the VLAN ID menu, press MENU/SELECT to enable or disable the WAN VLan.
VLAN:
Disabled
Port:
0
BACK
3. Press
to enter characters. The valid range is 0 to 4095.
4. Press
Configuration Using the Phone Menus
You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
OK

and enter the Subnet Mask. Use the dial pad to enter characters.

and enter the Gateway. Use the dial pad to enter characters.
OK .
VLAN ID
ENTER

and enter the WAN port number. Use the dial pad and the
SAVE .
VSP600 Administrator and Provisioning Manual
 
to highlight Set static IP, and then
or
 
to highlight VLAN ID, and then
or
20
BACKSP soft key
Back to Contents