Network Pages; Basic Network Settings - VTech ErisTerminal VSP735 Administrator And Provisioning Manual

Network Pages

You can set up the VSP735 for your network configuration on the Network pages. Your
service provider may require you to configure your network to be compatible with its
service, and the VSP735 settings must match the network settings.
The network settings are also available as parameters in the configuration file. See
""network" Module: Network Settings" on page
After entering information on this page, click

Basic Network Settings

If you disable DHCP on this page, you must configure static IP settings for the
VSP735. You must be familiar with TCP/IP principles and protocols to configure
static IP settings.
Basic Network Settings
Click the link for each setting to see the matching configuration file parameter in
Module: Network Settings" on page
Setting
Enable DHCP
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Using the WebUI
VSP735 Administrator and Provisioning Manual
112.
112. Default values and ranges are listed there.
Description
DHCP is selected (enabled) by default, which means the
VSP735 will get its IP address, Subnet Mask, Gateway, and
DNS Server(s) from the network. When DHCP is disabled,
you must enter a static IP address for the VSP735, as well
as addresses for the Subnet Mask, Gateway, and DNS
Server(s).
If DHCP is disabled, enter a static IP address for the VSP735.
Enter the subnet mask.
Enter the address of the default gateway (in this case, your
router).
If DHCP is disabled or you don't wish to use the
DHCP-assigned DNS server (or one specified by your
service provider), enter addresses for the primary and
secondary DNS servers.
62
to save it.
""network"
Back to Contents