Functional Overview; Keeping The Controller Awake; Interoperability With Z-Wave™ Devices - GE 45633 User Manual

To Recover Network Information:
1. Enter SETUP and select NETWORK.
2. Press OK. The screen will display RESET.
3. Use either Arrow key to select RECOVERY.
4. Press OK. The screen will display WAITING.
5. When the screen displays SUCCESS. You have successfully re-
covered network information. Be patient; the larger the network,
the longer it will take to complete this process.

FUNCTIONAL OVERVIEW

This device is based on the Z-Wave Controller Library and the Re-
mote Controller Generic Device Class. It controls devices through
the following Z-Wave Command Classes:
• Association Command Class
• Basic Command Class
• Binary Switch Command Class
• Configuration Command Class
• Controller Replication Command Class
• Encryption Command Class
• Lock Command Class
• Manufacturer Specific Command Class
• Multi-level Switch Version 1 Command Class
• Thermostat Command Class
• Version Command Class
When using the Basic Command Class to control devices the con-
troller will either transmit a value of 0(OFF) or 255(ON), depending
on the button pressed.

KEEPING THE CONTROLLER AWAKE

Under normal circumstances, the controller goes into stand-by
mode (sleep) after approximately10 seconds of inactivity (no but-
ton presses) in order to extend battery life. It may be desirable to
keep the controller awake for longer time periods so that another
controller can request Version or Manufacturer Specific informa-
tion. Press and hold the OK or Cancel button to keep the controller
awake for the desired time period.
INTEROPERABILITY WITH Z-WAVE™ DEVICES
27