Advertisement
Table of Contents
- 1 Place the Base on the Floor and Lock the Wheels.
- 2 Tighten with a 9/16” Wrench.
- 3 Remove the Display from Packaging.
- 4 Ensure that the Cart Casters Are Locked.
- 5 Adjust the Handles by Loosening the Two Screws on each Bar.
- 6 Connect the Speaker Wires.
- 7 Regulatory Notices and General Warnings
- 8 Educart 500 Wiring Diagram
- Download this manual
Setting Up the Polycom®
RealPresence® EduCart
© 2014, Polycom, Inc. All rights reserved. POLYCOM® and the names and marks associated with Polycom's products are trademarks and/or service marks of
Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. No portion hereof may be reproduced
or transmitted in any form or by any means, for any purpose other than the recipient's personal use, without the express written permission of Polycom.
500
TM
EagleEye IV Camera
Speakers
Poles
Base with
Locking Wheels
H Frame
Back
Cover
Basket
www.polycom.com
Polycom, Inc.
6001 America Center Drive
San Jose, CA 95002, USA
1725-08449-001/B
Flat Screen Display
Note that your display may
look different than the display
shown in this document.
"Grab"
Handles
Power Bar
RealPresence
Group 500
Codec
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Polycom RealPresence EduCart 500
Summary of Contents for Polycom RealPresence EduCart 500
- Page 1 Polycom, Inc. and are registered and/or common law marks in the United States and various other countries. No portion hereof may be reproduced or transmitted in any form or by any means, for any purpose other than the recipient’s personal use, without the express written permission of Polycom.
- Page 2 Remove the basket and basket bracket from the Attach the codec to the H frame with the H frame by removing the two screws circled in M3 x 8 Phillips pan head screws. red. Setting up the Polycom® RealPresence® EduCart...
- Page 3 M8 screws through the holes. either cut the foam or lift the display out. If this system is not used with a Polycom- supplied display, the display used must have VESA 400 mm x 400 mm or 400 mm x 600 mm...
- Page 4 Attach the vanity plate on the front of directly under the display on the outside of the the cart between the speakers. poles. Attach them with U-shaped brackets using nuts and a 7/16” wrench. Setting up the Polycom® RealPresence® EduCart...
- Page 5 Only EduCart 500 components should be plugged into the power outlet block. Do not power any other electrical equipment from this power outlet. Setting up the Polycom® RealPresence® EduCart...
- Page 6 Always apply the liquid first to a static-free cloth. For further information concerning the individual components of this equipment, please refer to the respective product literature. For support or service, please contact your Polycom® distributor or go to Polycom Support at www.polycom.com/support. Child Safety Warnings: ...
- Page 7 EduCart 500 Wiring Diagram Setting up the Polycom® RealPresence® EduCart...
Need help?
Do you have a question about the RealPresence EduCart 500 and is the answer not in the manual?
Questions and answers