Printing; Starting A Print Job - Sony UP-D898MD Instructions For Use Manual

"PRT.MENU" is displayed on the LCD.
4
Shift the menu lever to the left.
"READY" is displayed and the unit enters the
normal printing mode.
20

Printing

Printing
Before starting a print job, always check the following
points:
• Unit connected correctly? (page 11)
• Printer driver installed? (page 11)
• Paper loaded correctly? (page 12)
• Menu settings and adjustments done correctly?
(page 15)

Starting a Print Job

1
Press the power ON/OFF switch to on.
The back light on the LCD lights in green, and
"READY" is displayed on the LCD.
LCD
2
Execute the print job with the software application.
When the message is displayed on the LCD
If a problem occurs, the back light on the LCD lights in
orange and the error message stating the problem is
displayed on the LCD.
Message Cause and remedy
EMPTY:XX Paper is not loaded. Load paper.
DOOR:XX The door is open. Close the door.
XX indicates the selected paper type.
"S" means UPP-110S, "HD" means UPP-110HD, and
"HG" means UPP-110HG.
When the unit stops printing
When printing almost black images continuously, the
thermal head protection circuit may shut down the unit
to prevent the thermal head from overheating. In such a
case, the message "COOLING" is displayed on the
LCD.
Leave the unit until the head cools down and this
message disappears.