Storage; Configuring The Video Recording Schedule - Lorex LNR400 SERIES Instruction Manual

Hide thumbs Also See for LNR400 SERIES:
Table of Contents

Advertisement

15
Using the Main Menu
To configure network warnings:
1. From the Main Menu, click
2. Under Event Type, select the event type you would like to configure.
• Net Disconnection: The system has lost connection to the network.
• IP Conflict: More than one device on your network has the same IP address.
• MAC Conflict: More than one device on your network has the same MAC address.
• All: Configure responses for all network events.
3. Configure the following for the selected event type:
• Enable: Check to enable the selected event type.
• Show Message: Check to show a popup message when the selected event occurs.
• Send Email: Check to enable email alerts. You must configure email alerts before
you will be able to receive them (see 15.3.5 Configuring Email Alerts, page 56).
• Buzzer: Check to activate the system buzzer.
• Record Channel: If Net Disconnect is selected, you can set the system to trigger
recording after it loses connection to the network. Check Record Channel to ena-
ble video recording and select the channels you would like to record. Set the
amount of time you would like the system to record under Post_REC.
4. Click OK to save changes.

15.3.14 Storage

The Storage menu allows you to configure the recording schedule and hard drives con-
nected to the system.

15.3.15 Configuring the Video Recording Schedule

You can set a custom recording schedule according to your needs. For example, you can
set the system to record continuously during business hours and record on motion detec-
tion only outside of business hours.
A custom recording schedule helps reduce the amount of hard drive space required, in-
creasing the time your system can retain recordings.
To configure the video recording schedule:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure or select All.
#LX400021; r. 3.0/23574/23574; en-US
and then click Event>Warning>Network.
and then click Storage>Schedule>Record.
65

Advertisement

Table of Contents
loading

Table of Contents