Removing The Hard Drive - Lorex LNR400 SERIES Instruction Manual
Hide thumbs
Also See for LNR400 SERIES:
- Instruction manual (192 pages) ,
- Quick mobile manual (2 pages) ,
- Quick connection manual (2 pages)
Table of Contents
Advertisement
21
LNR400 Series Hard Drive Installation
5. Turn the system over carefully. Tighten the hard drive screws (4x) to secure the hard
drive.
CAUTION
Hold the hard drive in place when turning the system over to prevent damage to the system.
6. Connect the SATA power and data cable to the hard drive.
7. Replace the cover and cover screws (4x).
NOTE
After installation, you must format the hard drive in order to use it with the system. See 21.3 Format-
ting Hard Drives, page 170.
21.2 Removing the Hard Drive
CAUTION
Make sure that the system is OFF and ALL power adapters have been disconnected before removing/in-
stalling the hard drive.
1. Power off the system, and unplug all cabling from the system.
2. Remove the rear panel screws (4x). Remove the cover.
#LX400021; r. 3.0/23574/23574; en-US
169
Advertisement
Table of Contents
