TGB Outback 425 Owner's Manual page 16

MODE BUTTON
1. Press the MODE button to move all functions in loop sequence from one function
screen to another when the speed sensor does not detect any signal input.
2. Press the MODE button to move partial functions in loop from one
function screen to another when speed sensor detects signal input.
RESET BUTTON
1. Press MODE button to the desired screen then press RESET button for 2 seconds to
reset TRIP 2, MAX, and MAX RPM data from stored values to zero individually.
2. The data of Trip 1, AVG & RT is reset at the same time when one of the 3 data
functions is being reset.
3. ODO, clock and TT data cannot be reset.
1. Press MODE button to the RPM screen; pull on the throttle until the desired shift RPM
warning displayed.
2. Press RESET button to confirm and set up the shift warning RPM.
3. Bar-graphic tachometer will flash to warning you shift gear.
4. Operate items 1 & 2 to readjust the shift warning RPM.
1. Setup operations include 12/24hour clock, shift warning RPM, numbers of engine
rotation per signal, wheel circumference and units. These must be set up step by step.
The computer will automatically revert to main screen if no button operation for 75
seconds at any setting screen.
2. Press both MODE & RESET buttons to go into setting screen. In setting screens,
press RESET button to add the flashing digit by 1 or convert units, press MODE button
to confirm the digit setting and jump to next digit or next setting screen to be set. Press
MODE button for 2 seconds at any setting screen to finish the setting and go to main
screen.
3. It displays "12 or 24H and XX:XX-XX" symbols and AM/PM in case you select 12H.
4. Press RESET button converts 12/24H, press MODE button to complete the setting
and jump to clock digit setting.
5. Press RESET button to increase flashing digit by one; press MODE button to confirm
digit setting and jump to next digit.
6. Press MODE button to go to shift warning RPM setting screen after set clock.
7. It displays " RPM rXXX00 ". Press RESET button to increase flashing digit by one;
press MODE button to confirm digit setting and jump to next digit.
8. Press MODE button to go to numbers of engine rotation per signal setting screen after
completed shift warning RPM setting.
16
SHIFT RPM WARNING OPERATION