TGB Outback 425 Owner's Manual page 11

5.
Shift Lever
Notice Operating the shift lever when vehicle is moving can be
hazardous. This is strictly prohibited.
Always wait till the vehicle stops completely, do not operate the ATV at
high speed in reverse under any ciscumstances
6. 2WD/4WD SELECT LEVER
The 2WD/4WD SELECT LEVER is for the use of changing the engine
power supplied to the wheels. You can select 2WD or 4WD for your
preference according to different surface conditions.
2WD Supplying engine power only to the rear wheels. This is mainly use
for normal riding on dry surface or hard surfaces.
4WD Supplying engine power to both of the front and rear wheels, at the
same time, the right front wheel and left front wheel can be turned at
different speeds. This provides much more traction than 2WD and should
be used when riding on wet and slippery surfaces.
Shifting the 2WD/4WD lever
1. Stop the vehicle completely.
2. Place the lever to the preferred position.
WARNING
Shifting the lever when ATV is moving can be extremely dangerous...
can lose control while riding with a hand removed from the handlebar. The
gear box mechanism can be damaged if moving the shifting lever when
the ATV is in motion.
Always stop the ATV completely before shifting between 2WD and 4WD
11
L High torque use (advance gear)
H Normal use (driving gear)
N Parking use (Neutral)
R Reverse use
Shift lever instructions
1. Engine starts only in Neutral (N)
position
2. Engage a brake and push the knob in
and move the shift lever from N to H, L
or R
(L Shift is used for rough surfaces)
Æ ‡ Shifting H to L and any gear/direction
the vehicle must be at a complete
stand still
3. For reverse, with the brake on, push
the knob in and move the shift lever
from N to R