First Section - For The User - lamber L24-ek-plus Instruction Manual

First Section - FOR THE USER

WORKING AND USE
The dishwashing machine can wash up to 960/320 dishes per hour.
The machine protection degree is IP21, therefore it should not be washed with direct high pressure jet water;
The correct placing of the objects is an essential condition for a good washing-up result;
We suggest to descale dishes, from time to time, in order to remove calcareous and/or starchy sediments
by soaking it in suitable solutions suggested by your cleansing agent supplier.
If you need to buy new dishes remember the following:
Dishes and cups: preference must be given to china or non-porous pottery articles, with smooth surface.
Glasses: choose a glass suitable to be washed in dish-washing machines. Surfaces must be smooth and
bottoms as flat as possible.
INSTRUCTIONS BEFORE WASHING
B
EFORE STARTING THE WORKING OPERATION MAKE
:
SURE THAT
- the cock is open;
- the filters and
their housings;
- the wash arm and the rinse arm are free to
pivot;
- rinse aid and washing powder dispenser
containers are loaded.
T :
HEN PROCEED
1
- Open the hoor and put into the tank,
possibly over the pump-filter, about 110
gr. of detergent in powder. Every 10 cycles add
about 75 gr. of detergent.
If the machine is provided with an automatic
dosing device, make sure that the detergent is
in its container.
CAUTION: Observe the safety notes and
dosage data for the use of chemicals. During
the use of the chemical substance wear
protective clothing, gloves and protective
glasses. Do not
products.
TURN ON THE
operating state of emergency.
2
- Turn on the power using the switch on the
wall and press the switch "A" placed on the
control panel (DIAGRAM.1).
You will see the serial number of the machine
followed by the logo Lamber.
Close the hood of the dishwasher.
the overflow are in
mix different cleaning
MACHINE and
Press at this point the key switch "A"
control panel (draw 1)
At this point the LED will turn green and the
interactive display will show "Fill phase 1" that will
signal the start of the filling phase of the tank.
The filling phase is implemented in two stages.
In STEP 1 begins the load of the tank with water
from the water mains; in STEP 2 continues the
filling but also begins a warm-water washing.
Note: If the machine is
softener, during the FILLING PHASE 1 it will be
made to one or more cycles of Regeneration and
a subsequent Resins' Washing.
Attention: during tank filling don't open the hood
of the dishwasher!!
Attention!
If during the loading phase, appears the message
"BREAK TANK", this means that you're filling up
with water the rear Break Tank.
If after 5 minutes the data is still flashing in
alternation with the inscription FILLING PHASE 1,
you will see the word ALARM BEREAK TANK and
this will means that there may by a problem in the
tank loading. (Call the Technical Assistance
Service!)
11
ENGLISH
on the
equipped with water