Washing - lamber L24-ek-plus Instruction Manual

At the end of the filling phase of the tank on the
interactive display will appear the following
information (from left to right):
-Temperature of washing;
-Time of washing;
-Number of cycle;
-Temperature of rinsing..
The data of the temperature Tank and Boiler,
flashes slowly and increases in value, indicating
the current warming of the water in the boiler.
When temperature has reached, the data stops
flashing.
Attention !
The machine is programmed at the factory so you
can start the washing programm after filling the
tank up to the required level.
However, before you start the cycle, make sure
that the machine
temperature range (55°C for washing and 85°C
for rinsing):
In any case, the rinse will start only in
temperature regime reached. The duration of the
washing time chosen will then be continued until
it reaches the set temperature ((Thermocontrol).

WASHING

3
- Open the hood of the machine and insert
the basket. .
N.b.The display informs you when the top of the
dishwashers is open.
4
- Place the dishes in the racks, making sure
to first remove all the solid waste and fats.
Make a preventive soak to cutlery and possibly
even to dishes if they are washed after a long
time use. Do not overload the baskets, dishes
should not overlap, the water must have a way of
being able to invest directly in their entirety.
For a correct positioning of dishes see the specific
paragraph on page 16...
5
- Select the time of the washing cycle by
pressing the time selection "D"
has reached the
According to the following criteria:
- cycle 1 :short 1 minute ;
- cycle 2 : intermediate 2 minutes ;
- cycle 3 : long 3 minutes ;
- cycle 4 : infinite 15 minutes ;
The duration of the cycle must be chosen
according to the type of dirt to be removed from
the dishes.
See paragraph
programming, in the section dedicated to the
installer.
6
- Close the hood of the dishwasher.
Start at this point the washing cycle of the
chosen duration comprising in addition to washing
a rest period of 5 seconds, and a rinsing phase
lasting 15 seconds with clear water at 85°÷90°C.
(only for L305-CV)
At the end of the washing phase there is the
ideal
automatically activating of the fan for suction of
the vapors. This aspiration continues for a
programmable time from 0" a 60" beyond the end
of the
A beep indicates the end of the cycle.
To temporarly pause the cycle, simply open the
hood of the dishwasher.Closing it, the cycle will
start again at exactly the point were it was
interrupted.
It is possible at any time to stop the wash cycle by
simply pressing the button again cycle "B"
When you restart the cycle, this will restart from
the beginning.
(be carefull! During the cycle, at the opening of
the hood is pressed also the fan for fume
extraction for a maximum time of 20 seconds –
only to L305-CV)
12
,
specifically
rinse seconds (
(only for L305-CV)
.
for custom
default 20") .