Achievements - lamber L24-ek-plus Instruction Manual

7
- At the end of the wash cycle , the
message "END WASH" will appear followed by a
short beep.
The LED turns off and the B button appear the
temperature data and the data number and
duration of the cycle.
Open the hood of your dishwasher.
Remove the basket and tilting it, shake it lightly to
bring down the remaing drops. Allow to dry the
dishes by evaporation, then remove them from
the basket, taking care not to touch the inside
edge of the same. Then put them on hygienic
shelves.
To continue the wash load another basket and
close the hood. The
automatically.
If you want to change the wash cycle, before
closing the hood, you will need to select the new
cycle by pressing the time selection "D".
Temperature data display: to view temperature
data during the wash cycle, it is necessary to
press the push-botton
temperature data for 3".
If you want to fix the values of temperature for
the whole duration of the selected cycle, it is
necessary to press the button
To re-display the data of the wash cycle, it is
necessary to press the switch
Attention! At the next cycle the temperature data
will not be displayed automatically, but the data
will appear in the wash cycle.

ACHIEVEMENTS

Any deficiency in the washing process is
obvious when dirty residuals are visible. Any
halos might be caused by an insufficient rinsing:
in this case, check that the rinsing jets are clean
and that there is a sufficient pressure in the
water distribution network.
In case you find residuals, check that:
• the washing jets are clean
• there is some detergent
• the pump suction filter is clean
• objects in the rack are placed in a correct
position.
cycle will restart
You will see the
.
for 3".
.
STAND BY-ECONOMY
(only available on a machine with automatic
start!):
The stand-by function allows you to keep the
machine closed at rest, keeping active heating
functions.
keep
button
pressed
for 3 sec.
Stand-by : with open hood and the machine is in
"ON", press the cycle "B" push-button for 3
seconds, then closing the hood, the machine will
not operate the wash cycle while maintaining
active heating functions.
The display shows the word "ECONOMY". The
temperature of the heater stabilizes at 60°
reducing the consumption of energy.
Attention!: make sure, after you start the
stand-by function to close the hood to keep
the wash tank hot and not disperse heat!
To restart th cycle, put the top down and press
the push-button "B".
Automatic Stand-by : after 10 minuters of non-
use of the machine, with the hood open, it
automatically activates
ECONOMY, (the display shows the word
ECONOMY P*)
To restart the cycle, put the top down and press
the push-button "B".
If the machine is not used for 1 hour, the same
turns off completely (the machine "OFF", even
turning off the heating elements).
Turn on the machine by pressing the push-
button"A".
To restart the cycle, put the top down and press
the push-button "B".
SELF-WASHING
The function of self-washing allows you to make
a cleansing cycle at the inside of the washing
tank.
The inside of the washing tank is cleaned with
water coming from water network.
13
machine «ON»
To start cycle
press button
1
Hood
open
2
the STAND BY-