Descaling - lamber L24-ek-plus Instruction Manual

machine «OFF»
keep
button
Remove the
pressed
for 3 sec.
overflow
- Self-washing cycle: with the machine "ON" do
the following operations::
-1 Put the machine OFF by
push-button "A" ( led off)
-2 Remove the overflow of the tank and wait
until same is empty;
For machines equipped with drain pump, see the
instructions at the specific paragraph.
For machines without drain pump:
Visually check that the tank is empty,
-3 Close the hood of the dishwasher ;
-4 Hold the " " button for 3 seconds
ATTENTION: before your press the "
make sure that the display shows the logo lamber
".
"
In case it is off, turn the machine on by pressing the
switch "A" and then pressing it again to to turn off
again the push button "A"
The logo Lamber will reappear and will then be able to
start the function SELF-WASHING holding down the
select push button " " for 3 seconds
On the display you will see the words "SELF-
WASHING" with the time bar that indicates the
icrease for the duration of the cycle of 5 or 10
minutes depending on the time of rinse set by
default
If you want to stop the cycle SELF-WASHING, it
is sufficient to press the switch "A"
DRAIN PUMP INSTRUCTIONS (optional)
(only for machines with drain pump)
The pump discharge function allows you to
automatically download the wash tank at the end
of the workday.
machine«OFF»
keep
button
pressed Hood
for 3 sec.
open
The operation of
automatic only during the cleaning cycle to
drain the excess water that enters during the
rinsing phase
Wait the End
of the drain
(with drain pump
press button)
1
Hood
closed
2
pressing the
.
"
, button,
Remove the
overflow
1
2
the discharge pump
At the end of the working day, to discharge
the tank completely, you must perform the
following steps:
3
-1 Put the machine
4
switch "A" (the display shows LAMBER
logo);
-2 Open the hood of the dishwasher;
-3 Remove the OVERFLOW from the tank
4- Then press the "B" cycle-button for 3
seconds
Alternately
"REMOVE OVERFLOW"
(N.B. The word "REMOVE OVERFLOW" will
disappear only to the closing of the hood)
The discharge stops automatically after about 5
minutes.
The discharge can be interrupted at any time by
pressing the cycle-button "B"
After drainig, the machine will turn off
completely (display OFF).
Replace the overflow into place and close the
hood.
DESCALING (optional)
(only for machine with drain pump and
dispenser )
The descaling function is a cycle that leads
descaling liquid in the pipelines of rinsing, in the
washing tank and boiler allowing the removal of
limescale deposits from the water products.
The cycle lasts about 35 minutes.
For an average water limestone is recommended
cycle activation at least once a week.
The frequency may vary depending on type of
water.
To make the cycle do the following operations:
3
-1 Punt the machine OFF by pressing the
switch "A" (led off)
is
-2 Remove the OVERFLOW from the tank;
14
OFF by pressing the
flash the words "DRAIN"
machine «OFF»
keep
1
button
Remove the
pressed
overflow
for 3 sec.
2
and
keep button
pressed for 3 sec
and w ait the End
of the drain .
3
Hood
closed
4