Fitting The Cylinder Head; Method For Tightening The Cylinder Head - PEUGEOT Kisbee Workshop Manual

POWER UNIT
When re-installing, the camshaft bearings, the rocker shafts and the contact between the
rockers and the valves shall well lubricated in order to avoid any risk of seizure when starting
the engine (Use lithium soap grease). Seals and valve stems must be lubricated.

Fitting the cylinder head

- Fit the 2 guiding pillars and the metal
gasket (6) on the cylinder.
- Fit the timing chain through the cylinder
head timing well.
- Install the cylinder head.
You must set the timing every time you remove the cylinder head when servicing.

Method for tightening the cylinder head

- Fit the 4 washers.
- Tighten the 4 nuts (1) and the 2 washer
screws (2) slightly.
- Torque the 4 nuts in a crosswise order to
18 Nm and the 2 washer screws to 8 Nm.
68
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
1
6
2