Removal Of The Camshaft And/Or Rockers - PEUGEOT Kisbee Workshop Manual

POWER UNIT
- Hold the magnetic wheel to unscrew the
2 fastening screws from the camshaft
pinion.
- Remove the camshaft gear (7).
- Tie a wire to the timing chain in order to
prevent it from falling into the crankcase.
- Loosen the 2 washers screws (8).
- Gradually loosen in a crosswise order the 4
nuts which secure the cylinder head (9).
- Remove the cylinder head.

Removal of the camshaft and/or rockers

- Remove the pins from the rockers using a
5 mm screw.
- Remove the inlet (1) and exhaust (2)
rockers.
- Remove the stopper plate (3).
Tightening torque: 15 Nm.
- Remove the camshaft (4).
66
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
7
9
9
3
2
8
1
4