Bleeding The Circuit After Removing The Front Master Cylinder Or The Upper Front Hydraulic Hose (Right Side) - PEUGEOT Elystar Workshop Manual

Bleeding the circuit after removing the front master cylinder or the upper front hydraulic hose (right side)

The following operation must be carried out scrupulously, and consists in removing the air bubbles
from the circuit through the relevant master cylinder, in order to guarantee correct operation of the
brake circuits
- Protect any plastics which may be exposed to brake fluid splashes
- Remove the right master cylinder cover
- Fill the right master cylinder half full with
brake fluid
- Position the handlebar in order to create a high
point on the master cylinder to enable the bubbles
in the circuit to rise more easily
Essential precautions: 1) pumping with the brake lever must be carried out slowly.
Operate the brake lever slowly with a maximum movement of 2 cm from its rest position until no more
bubbles can be seen coming up through the master cylinder reservoir.
This operation can only be successful if it is not hurried.
- Remove the bleed screw cap from the control unit front circuit
- Connect the bleed screw (2) to a recipient
containing brake fluid using a transparent pipe. The
recipient must be kept higher than the control unit
to facilitate checking that the air bubbles are being
expelled.
- Open the bleed screw half a turn
Reproduction or translation, even partial, are forbidden without the written consent of Peugeot Motocycles
WORKING ON THE ABS/PBS SYSTEM
2) the lever must not come into contact with the handlebar.
Page : 39