Tocs (Tohatsu Onboard Communication System) Installation - TOHATSU MFS 40A Owner's Manual

Propeller must be selected that will allow
the engine to reach recommended rpm
when cruising at wide-open throttle.
Wide-open throttle rpm range
40/50
5000 – 6000 rpm
Genuine propellers are listed on PROPEL-
LER TABLE of this manual (See page 85).
1. Remove the split pin, propeller nut and
washer.
2. Apply water proof grease to the pro-
peller shaft before installing a new pro-
peller.
3. Install the thrust holder, propeller stop-
per, washer and propeller nut onto the
shaft.
2
1. Propeller
2. Thrust holder
3. Stopper
4. Washer
5. Nut
6. Split pin
4. Tighten the propeller nut to specifie
torque with holding the propeller by
wood block. And align one of grooves
to propeller shaft hole.
Propeller nut torque:
35 Nm (25 ft-lb, 3.5kgf-m)
5. Install a new split pin into the nut hole
ENOM00971-0
5. TOCS (Tohatsu Onboard
TOCS (Tohatsu Onboard Communication
1
3
System) interface coupler can provide
4
5
information regarding engine speed, fuel
consumption, and various malfunction via
an optional interface cable. Contact autho-
6
rized Tohatsu dealer for more detail.
ENOF00084-A
and bend it.
Communication System)
installation
25
INSTALLATION
ENOF00084-B
ENOF00933-0
5