Tocs (Tohatsu Onboard Communication System) Installation - TOHATSU MFS 25C Owner's Manual

ENOW00014-0
CAUTION
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system
will be damaged.
Do not disconnect the battery leads
from battery while the engine is operat-
ing, the electrical parts could be dam-
aged.
Always use a fully charged battery.
ENOW00015-0
CAUTION
Do not use a battery that is not recom-
mended. Use of a battery not recom-
mended can lead to poor performance of,
and/or damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 70AH/5HR,
650 (Cold Cranking Amps (CCA), In case of
cold whether: 12V100AH/5HR (850CCA))
Specifications and features of batteries vary
among the manufacturers. Consult the
manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the outboard
motor.
1. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery, and
then connect the negative lead (—).
W h e n d i s c o n n e c t i n g t h e b a t t e r y
always remove the negative lead (—)
first. After connecting the positive ter-
minal (+), securely place a cap on it to
prevent short circuits.
1
1. Battery cord (red)
2. Battery cord (black)
ENOM00971-0
4. TOCS (Tohatsu Onboard
Communication System)
installation
TOCS (Tohatsu Onboard Communication
System) interface coupler can provide
information regarding engine speed, fuel
consumption, and various malfunction via
an optional interface cable. Contact autho-
rized Tohatsu dealer for more detail.
27
INSTALLATION
2
ENOF00022-0
ENOF01146-0
5